Thanks for your quick reply! The solution was indeed to put the ./configure parameters on the same line; I also changed to a serial gateway which is now correctly recognized in Domoticz. I did not need to change any pin definitions (yet). Yeah, the two capacitors clearly shown are indeed not very effective for the radio module, there is however another capacitor directly soldered to the radio, which is a bit hidden in the picture. Thanks again for your help!

@alexsh1 Hi Alex, I tested the Sanity check on the the Arduino sensor node, and status came back OK. However I could get this to work on the Raspberry Pi, seems like this function is not yet supported. At least I couldn't find any info on it using the "./configuration -h". I don't have a AMS1117 available so I can test that. I connected my Arduino Nano and NRF24L01+ to the Raspberry Pi via USB, that would really well. So I might just use this solution instead as I see little benefit of connecting the NRF24L01 directly to the GPIO pins on the Raspberry Pi. Next step is to start building some battery powered sensors that I can use, and get MyController setup properly.

@micah said: @alexsh1 said: @micah I think you can get a Samsung Class 10 microSD card for like $10 or something. I would avoid using a noname card from eBay/Aliexpress. Saves a lot of time. BTW - this is hardly RPi's fault, isn't it? Your right, it isn't the RPi's fault, although would it kill them to just include an 8gb flash chip on the device Re flash on the device - That's completely different discussion. What needs to be onboard is an endless talk - there are a few of those threads on raspberry.org . Personally, I am fine with the microSD card.

Bens doesn't seem to come back that fast.. I opened a ticket to the rf24 library owner: https://github.com/TMRh20/RF24/issues/172#issuecomment-163117684

Hmmm... I am away from raspi, I prefer cubieboard and Odroid-U3 for reliability and reactiveness....